Heat transfer performance and flow characteristics of oil-ZnO nanofluid in an alternating flattened tube in dual-tube heat exchanger: Experimental and numerical approaches

Abstract

The present paper, for the first time, examines the influences of utilizing oil-ZnO nanofluid with different volume fractions φ = 0.5 %, 1 %, and 2 % in alternating flattened tubes (AFTs) with different alternating pitch angles of 30°, 45°, 60°, and 90° on the performance of a dual-tube heat exchanger (DTHE). This work is conducted experimentally and numerically for the Reynolds number (Re) range of 300 < Re < 1900 for oil-ZnO nanofluid and Re = 2000 for water. Based on the experimental results, the optimal case is selected for the numerical simulations of AFTs. The performance evaluation criterion (PEC) is defined for the simultaneous evaluation of pressure drop (Δp) and heat transfer coefficient (HTC). The results demonstrate that the overall heat transfer coefficient (U) and Δp are augmented with the inlet flow rate and the alternating angle between the pitches. Therefore, the maximum heat transfer (HT) and Δp correspond to the AFTs with the angle of 90° (AF4) at Re = 1900. The PEC amount of AF4 shows a 56 % enhancement compared to the circular tube. It is also observed that using copper oxide nanoparticles inside the oil improves the HT rate and Δp in the heat exchanger. Besides, an increment in φ increases U and Δp; however, the values of PEC show that the positive effects of the nanofluid are larger than their negative impacts in such a way that the PEC is improved by 64 % when the nanofluid with φ = 2 % is utilized in AFTs compared to the circular tube.