Abstract
A heat transfer numerical model is developed for friction stir welding of dissimilar materials Al 6061 and AZ31 alloy. Thermo-physical properties were experimentally determined for the stir zone and compared with the base alloys. Experimentally determined thermo-physical properties of the stir zone are not strictly the average values of the base alloys but exhibit a complex relationship with the microstructural features and the intermixing of Al and Mg in the weld region. The numerical model is employed to predict the temperature distribution on the advancing and retreating side. A good agreement between computed and experimentally measured results was obtained at 24-mm, 20-mm, and 16-mm tool shoulder diameter. The proposed model can be used to predict the thermal cycle, peak temperature, and thermo-mechanically affected zone for welding of dissimilar materials on friction stir welding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.