Heat Transfer Augmentation in 3D Inner Finned Helical Tube

Abstract

Experiments were performed to investigate the performance enhancement of single-phase flow and boiling heat transfer in the 3D inner finned helical tubes. The tests for single-phase flow and heat transfer were carried out in the helical tubes with a curvature of 0.0663 and a length of 1.15m, the range of the Reynolds number examined varies from 1000 to 8500. In comparison to the smooth helical tube, the experimental results of two finned helical tubes with different inner fin geometry showed that the heat transfer and flow resistance in the 3D inner finned helical tube gains greater augmentation. Within the measured range of Reynolds number, the average augmentation ratio of heat transfer of the two finned tubes are 71% and 103%, compared with the smooth helical tube, and 90% and 140% for flow resistance, respectively. The tests for flow boiling heat transfer was carried out in the 3D inner finned helical tube with a curvature of 0.0605 and a length of 0.668m. Compared with that in the smooth helical tube, the boiling heat transfer coefficient in the 3D inner finned helical tube is increased by 40%∼120% under varied mass flow rate and wall heat flux conditions, meanwhile, the flow resistance coefficient increased by 18%∼119%.