Heat transfer augmentation for turbulent flow in circular tubes using inserts with multiple curved vortex generator elements

Abstract

Measurements of local heat transfer coefficients on the circumference of a circular tube, fitted with two modified versions of an already existing axially inline curved Vortex Generator (VG) element insert are reported in this study. Measurements for average pressure drop are also presented and the air was used as the working fluid. The first modified insert is manufactured with a pair of two VG elements spaced symmetrically 180° apart but with the subsequent pairs along the axis staggered at an angle of 90°. The geometric features for the staggered insert were identical to the optimal one for the existing inline one. The staggered insert gives a more uniform circumferential and axial Nusselt number distribution. The ratio of the highest and lowest Nusselt number values for the staggered and inline case is equal to approximately 1.3 and 1.6 respectively. The average Nusselt number ratio at constant Reynolds number (10,000 < Re < 45,000) and constant pumping power however remained the same at about 2.6 and 1.5 respectively. The second modified insert was manufactured with three vortex generators placed symmetrically 120°apart at each axial location with all subsequent locations in line with one another. Two angles of attack 30°and 45° were used for the vortex generator elements and the pitch to projected length ratio of the VGs was varied between 1.6 and 12.2. The average heat transfer coefficient augmentation ratio using this insert at the equal Reynolds number and constant pumping power was obtained in the range of 1.5–5.5 and 1.0 - 1.8, respectively. The experimental data is presented in the form of empirical correlations for Nusselt number, and friction factor as a function of tube flow parameters, and non-dimensional geometrical parameters of VG inserts, which predict the data with an accuracy equal to ±20 %.