Heat Transfer Analysis of Flash Evaporation With MEPCM

Abstract

Several seawater desalination technologies have been developed and widely used during the last four decades. In the current investigation, a new approach to the seawater desalination process is presented, which utilizes microencapsulated phase change materials (MEPCMs) and thin film evaporation. In this process, the MEPCMs were placed into hot seawater. Then, the hot seawater and the MEPCMs containing the liquid phase change material (PCM) were ejected into a vacuum flash chamber. A thin liquid film of seawater was formed on the surface of the MEPCM, which subsequently vaporized. This evaporation significantly increased the evaporation heat transfer and enhanced the desalination efficiency. Film evaporation on MEPCM surfaces decreased their temperature by absorbing sensible heat. If their temperature was lower than the phase change temperature, the MEPCM would change phase from liquid to solid releasing the latent heat, resulting in further evaporation. The MEPCMs were then pumped back into the hot seawater, and the salt residue left on the MEPCMs could be readily dissolved. In this way, the desalination efficiency could be increased and corrosion reduced. A mathematical model was developed to determine the effects of MEPCM and thin film evaporation on desalination efficiency. An analytical solution using Lighthill's approach was obtained. Results showed that when MEPCMs with a radius of 100 µm and a water film of 50 µm were used, the evaporation rate and evaporative capacity were significantly increased.