Abstract
Abstract A preliminary design study has been made of some of the thermomechanical problems of water and helium cooling for the first wall of a near-term experimental fusion reactor. The first wall is envisioned as an array of 316 stainless steel tubes between the plasma and the blanket modules to intercept a heat flux from the plasma estimated to be between 0.25 and 1.0 MW/m 2 . Evaluations have been made of the maximum allowable heat fluxes for constraints imposed on the tube wall temperature, the cyclic stresses, the quasi-steady stresses and energy recovery from the coolant. For tubes with 2 meter long heated sections, 10 mm inside diameter and 1 mm wall thickness, water cooling was found to be more than adequate for plasma heat fluxes over 1 MW/m 2 with a fatigue life of 10 6 cycles; for a 2 mm wall thickness, at least 0.7 MW/m 2 can be handled for the same fatigue life. Helium-cooled tubes can also handle heat fluxes up to about 1 MW/m 2 with a 1 mm tube wall thickness and over 0.5 MW/m 2 with a 2 mm tube wall thickness, but the required pumping powers tend to be high. The problems of plasma disruptions and erosion by energetic plasma ions are also discussed briefly.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.