Heat and mass transfer characteristics of non-equilibrium flash at start stage

Abstract

Our experiments showed that a V shape pressure drop appeared at start stage of non-equilibrium flash. V shape pressure drop firstly denoted the generating of superheat degree, which should be the starting force driving the non-equilibrium flash. Then evaporated vapor made up the pressure drop. Finally, a dynamic equilibrium was reached between the flash rate and the outflow rate, and the pressure behaved decreasing gradually. However, few published references focus on this start stage of the non-equilibrium flash. In this paper, experiments of the flash were conducted to investigate the heat and mass characteristics during V shape start stage. Dimensionless flash conversion coefficient (FCC) was proposed to normalize the flash with different initial liquid mass at start stage. The effects of initial temperature and the valve opening degree on the heat and mass characteristics of flash during the V drop start stage were studied. The results showed that the pressure of the working fluid changed dramatically during the V drop start stage. The peak of instant liquid superheat was proportional to the opening degree of the valve, which controlled the outflow rate. The flash rate increased with increasing initial temperature and valve opening degree, which had an approximately linear relationship with the flash time. FCC increased with valve opening degree. It could be deduced that flash intensity or flash rate would be higher for an expander with larger outlet area or higher working temperature.