Abstract
Highly dispersed pure phases of binary and ternary nitrides (Co,Ni)Mo were prepared using decomposition of hexamethylenetetramine (HMTA) complexes. Their catalytic activity was evaluated in the HDS of thiophene and HDN of quinoline. Three different pre-treatment modes were applied, including direct in situ preparation of nitrides in the catalytic reactor; pre-sulfidation with hydrogen sulfide and soft oxidation in air followed by sulfidation. Pure bimetallic nitrides are highly active HDN catalysts in the absence of sulfur and show substantial synergy effect between Ni or Co and Mo. By contrast, no synergy was observed for thiophene HDS, specific surface rates for binary and ternary nitrides being similar to that of unsupported MoS 2. Transmission microscopy, XRD and XPS studies showed that MoS 2 segregation on the surface occurs during HDS reaction or sulfidation with H 2S. As a result bimetallic catalysts contained nitride particles covered with MoS 2 layers and VIII group metal sulfide crystalline particles in the subsurface layer. The introduction in the preparation sequence of an additional step of oxidation–sulfidation led to a considerable increase of HDS catalytic activity of bimetallic catalysts. Pre-sulfidation of nitrides with H 2S/H 2 mixture resulted in a drastic decrease of specific surface area (Ssp) and very low HDS activity. Soft sulfidation with thiophene under reaction conditions led to high Ssp and high HDS activity per unit of mass.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.