Abstract
This work presents a halftoning technique to manufacture 3D objects with the appearance of continuous grayscale imagery for Fused Deposition Modeling (FDM) printers. While droplet-based dithering is a common halftoning technique, this is not applicable to FDM printing, since FDM builds up objects by extruding material in semi-continuous paths. The line-based halftoning principle called ‘hatching’ is applied to the line patterns naturally occurring in FDM prints, which are built up in a layer-by-layer fashion. The proposed halftoning technique is not limited by the challenges existing techniques face; existing FDM coloring techniques greatly influence the surface geometry and deteriorate with surface slopes deviating from vertical or greatly influence the basic parameters of the printing process and thereby the structural properties of the resulting product. Furthermore, the proposed technique has little effect on printing time. Experiments on a dual-nozzle FDM printer show promising results. Future work is required to calibrate the perceived tone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.