Hard-Rock κ0 at KiK-Net Sites in Japan

Abstract

ABSTRACT Site-specific seismic hazard studies require the knowledge of the shear-wave velocity VS and the high-frequency site attenuation parameter κ0 at the reference rock level at depth. The latter one (called κ0,ref) is often not available and hard to derive. In this study, we make use of the KiK-net database in Japan that consists of surface and colocated downhole sensors. We select 175 sites where the bottom sensor is deployed at rock or hard-rock conditions resulting in a database with many recordings at VS≥1500 m/s. This allows us to tackle two questions: first, is it possible to derive κ0,ref from surface recordings? Second, does κ0 reach an asymptotic level at high VS that could be used as a κ0,ref in site-specific seismic hazard studies? Our results show that measures of κ0 derived from S and coda waves are equivalent. Thus, it is not possible to obtain κ0,ref from surface recordings using coda waves. On the other hand, S-wave measurements of κ0 from surface rock sites are close to κ0,ref if VS≥760 m/s or if the sedimentary cover is thin. The values of κ0 decrease with increasing VS and reach an asymptotic value. The scatter in the so obtained κ0,ref is high, but it can be reduced by selecting subregions with similar geological conditions. Finally, we observe that borehole and surface κ0 are correlated, and that the variability of κ0,ref is only slightly reduced compared to κ0 at the surface. Although we cannot exclude any influence of source effects, our findings indicate that κ0,ref has to be considered as a deep site parameter.