Abstract

On the basis of results of investigations and laboratory tests, a composite material produced by hard facing with a charge consisting of tungsten carbide particles and a Ni-Cr-B-Si alloy has been chosen as the most suitable for the surface reinforcement of parts operating under intense abrasive-gas wear conditions. To improve the processing qualities of such a charge, a flux should be added to it. The recommended charge composition for induction hard facing is: Relit 56–61%, PG-KhN80SR4 alloy powder 33–38%, boric anhydride 2.8–3%, dehydrated borax 1.5–1.6%, and silicocalcium 1.7–1.0%. Charges of this composition are being used for hard facing various parts of metallurgical plant units (small bells and charge distribution hoppers, valves of blast furnace charging devices, blades of sintering machines, and the like).

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.