Hands on explosives: Safety testing of protective measures

Abstract

Several attempts have been made to test the suitability of protective measures for the handling of explosives. We investigated the suitability of safety gloves and a combined safety helmet and face shield. In the presented studies, three different experimental setups were used to simulate the effects of an explosion of a primary explosive in a glass flask on the glove or helmet protected body. Depending on the experimental setup, the fragment effects were evaluated and compared. Furthermore, the fragment distribution of an explosion inside a glass flask was investigated. The explosion of 1 g of lead azide in a 10 mL flask yielded approximately 14,000 glass fragments. However, most of the shards were accelerated down- and side-wards and only few upwards. Holding a flask on its neck (instead of its bottom) is therefore a simple but effective way of diminishing the risk of injury, when handling explosives. The safety helmet/face shield performed very well, by shielding the face from all fragments. Furthermore, it could be proven that DIN and EN standard testing procedures for gloves are unsuitable to simulate the effects of a respective explosion. In this article, the progress in the development of realistic testing procedures for the testing of gloves for the protection against fragmentation effects of glassware in situations involving explosions is reported and the results and methods of previous tests are summarized.