Guidelines for descriptor assignments for the solvation parameter model by separation techniques

Abstract

The solvation parameter model uses six compound descriptors to model equilibrium properties in biphasic systems formally defined as excess molar refraction, E, dipolarity/polarizability, S, overall hydrogen-bond acidity, A, overall hydrogen-bond basicity, B, McGowan's characteristic volume, V, and the gas-liquid partition constant on hexadecane at 25 °C, L. The V descriptor can be assigned from structure and the E descriptor for compounds liquid at 20 °C can be calculated from its refractive index and characteristic volume. The E descriptor for compounds solid at 20 °C and the S, A, B, and L descriptors are assigned from experimental properties traditionally obtained by chromatographic, liquid-liquid partition, and solubility measurements. Here I report an efficient experimental design using the Solver method for the accurate assignment of descriptors for neutral compounds that simultaneously minimizes laboratory resources. This multi-technique approach requires 3 retention factor measurements in a 60 °C temperature range per compound on four columns by gas chromatography, 3 retention factor measurements in a 30 % (v/v) acetonitrile composition range per compound on two columns by reversed-phase liquid chromatography, and eight partition constant measurements by liquid-liquid partition in totally organic and aqueous biphasic systems for a total of 26 experimental measurements. The accuracy of the descriptor assignments was validated by comparison with the values in the Wayne State University (WSU) descriptor database taken as the best estimate of the true descriptor values. The E, S, A, B and L descriptors were assigned simultaneously by the Solver method using the above approach without significant bias and with an average absolute deviation (AAD) of 0.054, 0.018, 0.015, 0.013, and 0.040, respectively, compared with the WSU database values, corresponding to a relative absolute average deviation in percent (RAAD) of 7.2, 1.9, 3.6, 5.1, and 0.84 %, respectively, for 32 varied compounds. This streamlined approach represents a significant improvement on earlier single-technique approaches used as the starting point for the development of the multi-technique approach. For compounds of variable hydrogen-bond basicity modifications to the multi-technique approach were implemented while maintaining the same number of experimental measurements. Acceptable descriptor assignments for B/B° were obtained for compounds liquid at 20 °C for which the E descriptor was available by calculation. For solid compounds at 20 °C the E and B/B° descriptors are restricted to qualitative application where approximate values may be acceptable.