Guideline for Large-Scale Analysis of Centrifugal Blower Using Wall-Resolved Large Eddy Simulation

Abstract

Abstract To reduce the number of prototypes during product design and accurately predict unsteady phenomena occurring at off-design points, a method for accurately predicting the performance of centrifugal blowers through numerical analysis is required. This article presents a guideline for accurately predicting the performance of centrifugal blowers using compressible flow analysis with large eddy simulation (LES). In LES analysis, it is important to have a grid resolution that resolves the minimum vortex scale near the wall (referred to as wall-resolved LES) and to consider detailed geometry such as the length of the suction pipe. The calculations in this study used a model blower, which is a scale model of a single-stage centrifugal blower for use in industrial plants. The model blower was experimentally measured for various parameters such as the blower pressure coefficient, the static-pressure-rise coefficients of the impeller and vane-less diffuser, the shaft power, and the pressure fluctuations at the inlet of the impeller and the inlet of the vane-less diffuser. The results of these measurements were compared with those obtained from the wall-resolved LES. The study confirmed that the accuracy of performance prediction can be improved to less than a 4.0% error in the blower pressure coefficient at both design and off-design operating points by resolving the minimum vortex scale with 14.6 billion-grid elements and considering the detailed geometry.