Growth potential and biofilm development of nonstarter bacteria on surfaces exposed to a continuous whey stream

Abstract

Commercial Cheddar cheese production uses an automated, continuous production system that provides favorable conditions for specific undesirable bacterial subpopulations in certain sections of the processing system. The draining and matting conveyor (DMC) is a large, fully enclosed series of conveyor belts that separates curd and whey on the first drain belt and supports the cheddaring process in subsequent sections. In a previous study, we demonstrated that coliforms increase in the draining section of the DMC (pH 6.0-6.3, 36°C) over a typical 18-h production shift and can lead to detectable coliforms in finished cheese. Sampling at the commercial plant indicated 2 sources of very low levels of coliforms: (1) subpasteurized whey and curd entering the DMC and (2) surfaces in the DMC after sanitation. Mitigation of these sources would require different approaches. The aim of this study was to investigate whether naturally low levels of coliforms in whey could increase in the bulk liquid and attach to different surface materials within 18 h. A laboratory-scale system was created to mimic the conditions of the initial draining section of the DMC and consisted of single-pass, naturally contaminated whey (pH 6.3, 35°C) flowing through a bioreactor (1.11 L/h) containing coupons of surface types found in the DMC (stainless steel and polypropylene). Whey inside the bioreactor chamber and surface coupons were enumerated for bacterial subpopulations on selective media for planktonic and attached bacteria, respectively, at 0, 12, 15, and 18 h. Bacterial isolates were identified by 16S rDNA sequencing. Nonstarter bacteria present in the whey at 0 h included coliforms (Enterobacter), Pseudomonas, and Acinetobacter (0.80, 2.55, and 2.32 log cfu/mL, respectively), with each increasing significantly in whey (6.18, 7.00, and 5.89 log cfu/mL) and on coupons (5.20, 6.85, and 5.29 log cfu/cm2, respectively) after 18 h in the continuous flowing system. Scanning electron microscopy confirmed bacterial attachment on both surfaces, with early biofilm development evident on polypropylene coupons by 18 h. Results from this laboratory-scale study demonstrated that naturally low levels of coliforms entering the DMC in the whey could replicate within the conditions of the draining section of the DMC to the levels found in the commercial production environment.