Abstract
We propose a new method for the measurement of (group) delay from the radio-frequency (RF) input to the intermediate-frequency (IF) output of a mixer or a receiver. The method is particularly convenient for measuring the change in group delay with the local-oscillator (LO) tuning frequency of the receiver since the method does not require access to, or even knowledge of, the LO signal. The method employs a calibrated comb (impulse) generator. Other required equipment is limited to a reference signal generator and a digitizer of modest bandwidth, allowing the measurement to rely on a low-frequency generator and an oscilloscope. Simulated and measured data are presented to verify the approach.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
