Groundwater Flow Model Calibration Using Variable Density Modeling for Coastal Aquifer Management

Abstract

The paper investigates the mechanism of seawater intrusion and the performance of free and open-source codes for the simulation of variable density flow problems in coastal aquifers. For this purpose, the research focused on the Marathon Watershed, located in the northeastern tip of Attica, Greece. For the simulation of the groundwater system, MODFLOW, MT3DMS and SEAWAT codes were implemented, while sensitivity analysis and calibration processes were carried out with UCODE. Hydraulic head calibration was performed on the MODFLOW model, and TDS concentration was validated in the SEAWAT model. The calibrated parameters of the MODFLOW model were obtained for the variable density flow simulation with SEAWAT. The MODFLOW and SEAWAT hydraulic head outputs were analyzed and compared to one another. The outcome of this analysis is that SEAWAT produced slightly better results in terms of the hydraulic heads, concluding that parameter transferability can take place between the two models. For the purpose of the seawater intrusion assessment, the use of the SEAWAT code revealed that the aquifer is subjected to passive and passive–active seawater intrusion during wet and dry seasons, respectively. Finally, an irregular shape of a saltwater wedge is developed at a specific area associated with the hydraulic parameters of the aquifer.