Abstract

Different geophysical tools such as geoelectric, gravity, and magnetic have been applied to detect groundwater potentiality and structural elements, which controlled a geometry of the groundwater aquifers in the study area. Nineteen vertical electrical soundings measured using ABEM SAS 4000 equipment through Schlumberger configuration of AB/2 ranged from 1.5 to 1,000 m; the quantitative interpretation was carried out using manual and analytical techniques. The results of quantitative interpretation used to construct six geoelectrical cross-sections indicate that the subsurface sequence of the study area consists of seven geoelectrical units. These units are Quaternary sand sheet and sand dunes, Quaternary aquifer, marly limestone, clay, sandy clay, clay with sandstone intercalation, and deep Nubian sandstone aquifer. The isopach map of the Quaternary aquifer exhibits thickness of the Quaternary aquifer that increased at the northern and southern part (50 m) and decreased at the eastern and western part (5 m), and the depth of the aquifer increased at the northern part (40 m) and decreased at the central part to 6 m. The isoresistivity map of the aquifer shows a high resistivity at the northern part but the southern part reveals low resistivity according to the lithology. The water salinity increases in the direction of groundwater flow from 500 to 10,500 mg/l. The low water salinity is due to direct recharge from El-Sheikh Zayed Canal, which supplied fresh water to this area. Sixty-five gravity stations were measured using Auto-Grav gravity meter; different gravity corrections were applied on raw data. The corrected gravity values were plotted to represent a Bouguer anomaly map; the residual gravity anomaly map was used for delineation of the fault elements. The area was dissected by different fault elements of trends NW–SE, NE–SW, and E–W. In addition, 65 ground magnetic stations were measured at the same sites of gravity stations. The results of magnetic interpretation indicate that the depth of the basement is shallow at the western and southern parts of the area (4,500 m), but the central part exhibits greater depth of 7,900 m.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call