Abstract
Abstract This article addresses studies of basic mechanical defects conducted with the proprietary FAM-C method on a test bench created on the basis of ground power unit LUZES. The following mechanical defects were modelled in laboratory conditions: skewed connections, eccentricity of connections, increased circumferential clearance, increased intertooth clearance, etc. The thesis was put forward that tests on LUZES equipment enable to transfer experience onto the more complex helicopter power unit. The aim is the early defect detection of these units.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.