Greenhouse gases emissions from duckweed pond system treating polyester resin wastewater containing 1,4-dioxane and heavy metals

Abstract

Phytoremediation of polyester resin wastewater containing 1,4-dioxane and heavy metals using Lemna gibba (L.gibba) was enhanced by incorporation of perforated polyethylene carrier materials (PCM) onto the duckweed pond (DWP) system. The DWP module was operated at a hydraulic retention times (HRTs) of 2, 4 and 6 days and as well as 1,4-dioxane loading rate of 16, 25 and 48 g/m3.d. The maximum removal efficiency of 54 ± 2.5% was achieved for 1,4-dioxane at an HRT of 6 days and loading rate of 16 g1,4-dioxane/m3.d. Similarly, the DWP system provided removal efficiencies of 28.3 ± 2.1, 93.2 ± 7.6, 95.7 ± 8.9 and 93.6 ± 4.9% for Cd2+, Cu2+, Zn2+ and Ni2+ at influent concentration of 0.037 ± 0.01, 1.2 ± 0.9, 27.2 ± 4.7 and 4.6 ± 1.2 mg/L respectively. The structural analysis by Fourier-transform infrared spectroscopy (FTIR) clearly displayed a reduction of 1,4- dioxane in the treated effluent. A strong peak was detected for L. gibba plants at frequency of 3417.71 cm−1 due to N–H stretching, which confirm the proposed mechanism of partially conversion of 1,4-dioxane into amino acids. Glycine, serine, aspartic, threonine and alanine content were increased in L. gibba by values of 35 ± 2.2, 40 ± 3.2, 48 ± 3.7, 31 ± 2.8, and 56 ± 4.1%, respectively. The contribution of DWP unit as a greenhouse gases (GHG) emissions were relatively low (1.65 gCO2/Kg BODremoved.d., and 18.3 gCO2/Kg biomass.d) due to photosynthesis process, low excess sludge production and consumption of CO2 for nitrification process (1.4 gCO2/kgN removed.d). Based on these results, it is recommended to apply such a technology for treatment of polyester resin wastewater containing 1,4-dioxane and heavy metals at a HRT not exceeding 6 days.