Green Thermal Aggregates: Influence of the Physical Properties of Recycled Aggregates with Phase Change Materials.

Abstract

Increasing construction and demolition waste (CDW) and the large amount of energy consumption in the building operation process are high-profile issues at present. In the construction industry, recycled aggregated (RA) from CDW can be reutilized in construction, along with green materials, for example, as a road base layer, as aggregate in concrete, etc. Phase change materials (PCM) are often used as building materials due to their good latent heat storage properties. With the use of RA as a matrix to absorb PCM, a thermal performance aggregate can be obtained. This work studied the physical properties of RA from Portugal and combined PCM with RA to prepare a green thermal aggregate through two methodologies using a vacuum and atmospheric pressure. The green aggregate was used in concrete to observe its effect on the compressive strength of concrete. The results showed that the amount of PCM absorbed by the RA mainly depends on the porosity of the matrix material. At the same time, the volume expansion coefficient of PCM was 2.7%, which was not enough to destroy the RA. Ultimately, as the amount of green thermal aggregate increases, the compressive strength of concrete decreases. Green thermal aggregate prepared under vacuum conditions has a greater negative impact on the compressive strength of concrete.