Green Polymer Electrolytes Prepared by a Cost-Effective Approach.

Abstract

The preparation of solid polymer electrolytes (SPEs) using poly(ethylene oxide) (PEO) typically involves incorporating fillers or undergoing chemical modifications to reduce crystallinity and enhance conductivity. PEO with a lower molecular weight, known as polyethylene glycol (PEG), exhibits higher conductivity, despite weaker mechanical strength. It is commonly employed as a plasticizer to improve the conductivity of SPEs or to fabricate PEG-based gel polymer electrolytes (GPEs). In this study, we use a straightforward approach to create innovative SPEs by blending liquid polymer electrolytes (LPEs), particularly low-molecular-weight polyethylene glycol (PEG), with a molecular weight of 400 g/mol, and sustainable poly(l-lactide) (PLLA). Solid PEG/PLLA forms are achieved by introducing 30 wt % of PLLA. Subsequently, the addition of lithium salts results in the development of novel PEG/PLLA SPEs. Another focal point of this study involves incorporating 1,3:2,4-dibenzylidene sorbitol (DBS) into these PEG/PLLA systems. DBS, an organic gelator derived from natural sugars, demonstrates self-assembly, leading to the formation of a nanofibrillar network structure. Leveraging DBS's ability to form organogels in liquid organic environments, we facilitate the transformation of low PLLA content LPEs into innovative solvent-free GPEs. Our prepared PEG/PLLA SPEs exhibited a maximum conductivity value of 4.39 × 10-5 S/cm, approximately five times higher than that of neat PEG (10000 g/mol) SPEs. The ionic conductivity exhibited a declining trend as the content of PLLA and DBS increased. However, there was an improvement in electrochemical stability. Furthermore, the incorporation of PLLA and DBS into electrolytes contributed to enhanced mechanical support and stability within the electrolyte layer. This, in turn, mitigated capacity decay and improved the cycling performance of assembled lithium-ion cells.