Abstract

As training experience increases it becomes more challenging to induce further neuromuscular adaptation. Consequently, strength trainers seek alternative training methods in order to further increase strength and muscle mass. One method is to utilize accentuated eccentric loading, which applies a greater external load during the eccentric phase of the lift as compared to the concentric phase. Based upon this practice, the purpose of this study was to determine the effects of 10 weeks of accentuated eccentric loading vs. traditional isoinertial resistance training in strength-trained men. Young (22 ± 3 years, 177 ± 6 cm, 76 ± 10 kg, n = 28) strength-trained men (2.6 ± 2.2 years experience) were allocated to concentric-eccentric resistance training in the form of accentuated eccentric load (eccentric load = concentric load + 40%) or traditional resistance training, while the control group continued their normal unsupervised training program. Both intervention groups performed three sets of 6-RM (session 1) and three sets of 10-RM (session 2) bilateral leg press and unilateral knee extension exercises per week. Maximum force production was measured by unilateral isometric (110° knee angle) and isokinetic (concentric and eccentric 30°.s−1) knee extension tests, and work capacity was measured by a knee extension repetition-to-failure test. Muscle mass was assessed using panoramic ultrasonography and dual-energy x-ray absorptiometry. Surface electromyogram amplitude normalized to maximum M-wave and the twitch interpolation technique were used to examine maximal muscle activation. After training, maximum isometric torque increased significantly more in the accentuated eccentric load group than control (18 ± 10 vs. 1 ± 5%, p < 0.01), which was accompanied by an increase in voluntary activation (3.5 ± 5%, p < 0.05). Isokinetic eccentric torque increased significantly after accentuated eccentric load training only (10 ± 9%, p < 0.05), whereas concentric torque increased equally in both the accentuated eccentric load (10 ± 9%, p < 0.01) and traditional (9 ± 6%, p < 0.01) resistance training groups; however, the increase in the accentuated eccentric load group was significantly greater (p < 0.05) than control (1 ± 7%). Knee extension repetition-to-failure improved in the accentuated eccentric load group only (28%, p < 0.05). Similar increases in muscle mass occurred in both intervention groups. In summary, accentuated eccentric load training led to greater increases in maximum force production, work capacity and muscle activation, but not muscle hypertrophy, in strength-trained individuals.

Highlights

  • Both the maintenance and improvement of strength and muscle mass are important goals of physical training interventions in a variety of populations (Voet et al, 2013; Stewart et al, 2014), with resistance training being the most popular method for achieving these outcomes

  • The aim of this study was to determine the effects of accentuated eccentric load resistance training on lower-limb maximum and repeated force production, muscle activation, and muscle hypertrophy in already strength-trained men

  • Systematic heavy resistance training led to distinct improvements in neuromuscular performance and knee extensor muscle mass in both TRAD and accentuated eccentric load-training group (AEL) intervention groups when compared to a continuing, unsupervised control group (CON) within the first 5-week mesocycle

Read more

Summary

Introduction

Both the maintenance and improvement of strength and muscle mass are important goals of physical training interventions in a variety of populations (Voet et al, 2013; Stewart et al, 2014), with resistance training being the most popular method for achieving these outcomes. Training using mechanically driven isokinetic devices allows the individuals to perform (near)maximal contractions during both concentric and eccentric actions. Studies utilizing these devises have shown that performing concentric-only or eccentric-only actions in previously untrained subjects has led to similar gains in maximum isometric and/or concentric force production (Seger and Thorstensson, 2005; Franchi et al, 2015) and that training with fast eccentric-only actions can lead to increased torque during fast concentric actions (Paddon-Jones et al, 2001). Some studies have shown a reduced efficacy for eccentric-only training to elicit improvements in concentric force production (Komi and Buskirk, 1972; Higbie et al, 1996; Hortobágyi et al, 1996; Reeves et al, 2009; Roig et al, 2009), which has led to suggestions of action-specific adaptations due to training with eccentric-only actions

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call