“Gray Zone” Simulations Using a Three-Dimensional Planetary Boundary Layer Parameterization in the Weather Research and Forecasting Model

Abstract

Abstract Generating accurate weather forecasts of planetary boundary layer (PBL) properties is challenging in many geographical regions, oftentimes due to complex topography or horizontal variability in, for example, land characteristics. While recent advances in high-performance computing platforms have led to an increase in the spatial resolution of numerical weather prediction (NWP) models, the horizontal gridcell spacing (Δx) of many regional-scale NWP models currently fall within or are beginning to approach the gray zone (i.e., Δx ≈ 100–1000 m). At these gridcell spacings, three-dimensional (3D) effects are important, as the most energetic turbulent eddies are neither fully parameterized (as in traditional mesoscale simulations) nor fully resolved [as in traditional large-eddy simulations (LES)]. In light of this modeling challenge, we have implemented a 3D PBL parameterization for high-resolution mesoscale simulations using the Weather Research and Forecasting Model. The PBL scheme, which is based on the algebraic model developed by Mellor and Yamada, accounts for the 3D effects of turbulence by calculating explicitly the momentum, heat, and moisture flux divergences in addition to the turbulent kinetic energy. In this study, we present results from idealized simulations in the gray zone that illustrate the benefit of using a fully consistent turbulence closure framework under convective conditions. While the 3D PBL scheme reproduces the evolution of convective features more appropriately than the traditional 1D PBL scheme, we highlight the need to improve the turbulent length scale formulation. Significance Statement The spatial resolution of weather models continues to increase at a rapid rate in accordance with the enhancement of computing power. As a result, smaller-scale atmospheric features become more explicitly resolved. However, most numerical models still ignore the impact of horizontal weather variations on boundary layer flows, which becomes more important at these smaller spatial scales. To address this issue, we have implemented a new modeling approach, using fundamental principles, which accounts for horizontal variability. Our results show that including three-dimensional effects of turbulence is necessary to achieve realistic boundary layer characteristics. This novel technique may be useful for many applications including complex terrain flows, pollutant dispersion, and surface–atmosphere interaction studies.