Abstract
In this study, graphene oxide and composites of graphene oxide-iron modified clinoptilolite were synthesized and used for arsenate removal from aqueous solution. All adsorbents were characterized using X-ray diffraction and specific surface area analysis. The specific surface areas of composites were found to be less than the iron modified clinoptilolite. The time required to reach equilibrium was determined as 3 hours for all adsorbents. The Box-Behnken statistical experiment design method was used to determine the effects of initial arsenate concentration, pH and the amount of adsorbent on the percent arsenate removal. Graphene oxide was not as effective as composites for arsenate adsorption from water. Arsenate adsorption on composites was showed good compatibility with the Freundlich isotherm. The maximum arsenate uptake was realized at pH 4 for graphene oxide and at pH 7 for composites. The maximum adsorption capacities obtained at the optimum points determined by using the Box-Behnken design method were calculated as 39.49, 117.98 and 124.64 µg.g−1 for graphene oxide and composites, respectively.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Environmental Science and Health, Part A
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
