Granular limestone amended sand filters for enhanced removal of nanoplastics from water: Performance and mechanisms

Abstract

Effluent from wastewater treatment plants (WWTPs) has been regarded as one of the major contributors of nanoplastics (NPs) in the environment. Improving the performance of rapid sand filter (RSF) systems in WWTPs is thus in urgent need. In this study, granular limestone, a low-cost and abundant natural material, was integrated into RSF systems to enhance NP removal from water. Laboratory filtration columns packed with pure sand and limestone-amended sand were applied to remove polystyrene nanospheres (100 nm) from deionized water (DIW) and artificial wastewater (AWW) under different grain size and flow velocity conditions. Pure sand filter showed neglectable NP removal from DIW but much higher NP removal from AWW, especially when fine sand was employed. Limestone amended RSF had a significant improvement in the removal of NPs for all the tested conditions and the removal efficiency of NPs became greater with increasing amount of limestone in columns. The sensitivity of NP immobilization to flow velocity changed significantly with different combinations of filter and background solutions. Coupled effects of physical straining, electrostatic interaction, cation screening and bridging, and surface roughness controlled the retention behaviors of NPs in the columns. The higher removal efficiency of NPs by limestone can be mainly attributed to its chemical composition as well as its surface heterogeneity and roughness. Results of this study demonstrate that limestone can offer extensive application potential for enhancing the performance of RSF systems in WWTPs to remove NPs from wastewater.