Grain size effects on the oxidation of two ternary Cu–Ni–20wt.% Cr alloys at 700–800 °C in 1 atm O 2

Abstract

Two nanocrystalline two-phase Cu–Ni–Cr alloys, both prepared by mechanical alloying and containing about 20 at.% Cr but with different Ni contents (40 and 20 wt.%, respectively), have been oxidized in 1 atm O 2 at 700–800 °C. Their oxidation behavior has been compared with that of two cast alloys of the same composition, already studied previously, to examine the effects of a large reduction of the size of the individual phase grains and particles. The nanophase alloy with 40 wt.% Ni formed a flat external layer of chromia of regular thickness, while the corresponding cast alloy produced a very irregular chromia layer, often protruding deeply into the alloy, only after an initial stage of rather fast corrosion involving also copper and nickel, associated with some degree of internal oxidation. By oxidation at 700 °C the nanophase alloy with 20 wt.% Ni formed an irregular chromia layer associated with low corrosion rates. The corresponding cast alloy formed complex scales containing Cu, Ni and Cr oxides, extending into the alloy in the form of large pegs, even though a very irregular and discontinuous innermost chromia layer was still able to produce low corrosion rates. On the contrary, at 800 °C both alloys formed complex scales containing mixtures of the oxides of the three metal components. However, the scales grown on the cast alloy were much more irregular in thickness and formed large protrusions into the alloy. In spite of this, the corrosion kinetics of the nanophase 20 wt.% Ni alloy at 800 °C were more irregular and, except for an initial stage, less protective than that of the cast alloy with the same composition.