Grain boundary microstructure and fatigue crack growth in Allvac 718Plus superalloy

Abstract

The correlation between grain boundary microstructure and fatigue crack growth with hold-times was investigated for two conditions of the superalloy Allvac 718Plus; a Standard condition with the recommended distribution of grain boundary phases and a Clean condition with virtually no grain boundary phases. Fatigue testing was performed at 704°C using 10Hz cyclic load with intermittent hold-times of 100s at maximum tensile load. Microstructural characterization and fractography were conducted using scanning- and transmission electron microscopy techniques. Auger electron- and X-ray photoelectron spectroscopy techniques were used for oxide analyses on fracture surfaces. It was found that in the Standard condition crack growth is mostly transgranular for 10Hz loading and intergranular for hold-times, while for the Clean condition crack growth is intergranular in both load modes. The lower hold-time crack growth rates in the Standard condition are attributed to grain boundary δ-phase precipitates. No effect of δ-phase was observed for 10Hz cyclic loading crack growth rates. Two different types of oxides and oxide colours were found on the fracture surfaces in the Standard condition and could be correlated to the different loading modes. For cyclic loading a bright thin Cr-enriched oxide was dominate and for hold-times a dark and slightly thicker Nb-enriched oxide was dominant These oxide types could be related to the oxidation of δ-phase and the matrix respectively. The influence of δ-phase precipitates on crack propagation is discussed.