Abstract
Well-defined poly(N-isopropyl acrylamide) (PNIPAAm) brushes on commercial hydrophobic poly(vinylidene fluoride) (PVDF) microfiltration membrane surfaces were prepared, via direct atom transfer radical polymerization (ATRP) with the secondary fluorinated site of PVDF as initiator and water as solvent at 80°C. The effect of solvents on the ATRP was studied in detail. The water as reaction solvent was in favor of surface-initiated ATRP of N-isopropyl acrylamide (NIPAAm) from secondary fluoride of PVDF membranes. The chemical composition and structure of the modified PVDF membrane surfaces were determined by attenuated total reflectance (ATR) Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy. The surface and cross-section morphology of membranes were studied by scanning electron microscopy (SEM). The pore sizes of the pristine PVDF membrane and the PNIPAAm-grafted PVDF membranes were measured using micro-image analysis and process software. The introduction of the well-defined PNIPAAm on the PVDF membrane gave rise to hydrophilicity. Water contact angles of PVDF membranes reduced after the surface grafting of PNIPAAm. Water fluxes and protein solution permeation experiments revealed that the PNIPAAm-grafted PVDF membranes exhibited temperature-responsive permeability. The unique microstructure of PNIPAAm brushes facilitated hydrophilicity below the lower critical solution temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.