Abstract
This paper presents a comparison of contact and immersion waves used to measure residual stresses. The residual stresses are produced due to a dissimilar welding of stainless steel (304) to carbon steel (A106). Longitudinal critically refracted (LCR) wave propagated by 2 MHz contact and immersion ultrasonic transducers is employed to measure the residual stresses. A Finite Element (FE) model of welding process, which is validated by hole-drilling method, is used to verify the ultrasonic results while an acceptable agreement is achieved. The best agreement is observed in the parent material while the maximum difference is measured in the heat affected zone (HAZ). The results show no considerable difference between using contact and immersion transducers in ultrasonic stress measurement of dissimilar joints.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
