Glypican-3 electrochemical aptamer nanobiosensor based on hemin/graphene nanohybrids peroxidase-like catalytic silver deposition.

Abstract

AGlypican-3 (GPC3) electrochemical aptamer nanobiosensor based on hemin/graphene nanohybrids (HGNs) peroxidase-like catalytic silver deposition and GPC3 aptamer has been constructed for the determination of GPC3. The HGNs were prepared by anone-step reduction method. Fourier transform infrared spectroscopy (FT-IR), ultraviolet spectroscopy (UV-vis), and transmission electron microscopy (TEM) were used to study the structure and morphological characteristics of the HGNs. TheGPC3 electrochemical aptamer nanobiosensor was constructed using HGNs-aptamer (HGNs-Apt) as the signal probe and GPC3 aptamer as the capture probe. With the help of thecatalytic action of peroxidase-like properties of HGNs, H2O2 reduces the silver (Ag) ions in solution to metallic Ag, which deposit on the surface of the electrode. The amount of deposited Ag, which was derived from the amount of GPC3, was quantified by differential pulse voltammetry (DPV). Under optimal conditions, the current response of Ag had a good positive correlation with the GPC3 concentration in the range 10.0-100.0μgmL-1 with acorrelation coefficient of 0.9958. The detection limit was 3.16μgmL-1 at a signal-to-noise ratio of 3, and the sensitivity was calculated to be 0.807μAμM-1cm-2. The method is validated by analyzing spiked human serum samples with good recovery rangingfrom 101 to 122%. In addition, the GPC3 electrochemical aptamer nanobiosensor has acceptable selectivity, stability, and reproducibility. Graphical abstract A Glypican-3 electrochemical aptamer nanobiosensor based on hemin/graphene nanohybrids (HGNs) peroxidase-like catalytic silver deposition and GPC3 aptamer has been constructed for the determination of GPC3. The electrochemical aptamer nanobiosensor exhibits high selectivity, acceptance reproducibility, and good recovery performances.