Glucose detection with surface plasmon resonance spectroscopy and molecularly imprinted hydrogel coatings

Abstract

Listen

Translate article

Molecularly imprinted hydrogel membranes were developed and evaluated for detection of small analytes via surface plasmon resonance spectroscopy. Imprinting of glucose phosphate barium salt into a poly(allylamine hydrochloride) network covalently bound to gold surfaces yielded a selective sensor for glucose. Optimization of relative amounts of chemicals used for preparation of the hydrogel was performed to obtain highest sensitivity. Addition of gold nanoparticles into the hydrogel matrix significantly amplified its response and sensitivity due to the impact of gold nanoparticles on the refractive index of the sensing layer. Evaluation of its selectivity showed that the sensor displayed preferential recognition to glucose compared to structurally related sugars in addition to being unaffected by phosphate as well as compounds containing amine groups, like creatinine. The detection limit of glucose in deionized water was calculated to be 0.02mg/mL. The developed sensor was finally exposed to human urine spiked with glucose illustrating the coating's ability to re-bind the analyte in complex matrices. While the working concentration range in water was determined to be suitable for glucose monitoring in diabetic individuals at physiological levels, the detection in urine was determined to be 0.12mg/mL. The decreased performance in urine provided an initial perspective on the difficulties associated with measurements in complex media.