Geothermal evolution of an intruded dike in the rift zone of Kilauea volcano, Hawaii from VLF and self-potential measurements

Abstract

Self-potential (SP) and VLF measurements were made in 1973, 1975, 1995, 1997 and 2012 across a basaltic dike that intruded into the Koae fault zone of Kilauea volcano, Hawaii in May 1973. The SP anomaly remained strong throughout. In 2012 it was at about 60% of the strength it had in 1973. In contrast, the VLF anomaly, though diminished, was still observable in 1995/1997, but by 2012 it had disappeared. A hydrothermal dike model, with parameters calibrated by modeling the solidification of Kilauea Iki lava lake, is used to calculate temperatures and conductivity variation. Following Jaeger's (1957) method, we find that the time in years for a dike of width W (m) to solidify is 0.0075W2. Thus, a 1m dike solidifies within the first few days, and after 39years is only tens of degrees above ambient. Given the orders of magnitude difference between the conductivities of wet and dry basalt, we infer, that after solidification, the VLF anomalies were caused by induction in a localized veil of wet, hot basalt enveloping the dike, that was generated initially by condensation of steam, and subsequently by condensation of evaporated water as temperatures reduced. The conductivity anomaly persisted until the mid-nineties. By 2012, temperatures and condensation were too small for a VLF signal. The persistent SP anomaly is attributed to localized fluid disruption, with evaporation mainly at the water table and in the vadose zone. Streaming potentials are associated with evaporative circulation in the vadose zone. Next to the dike a positive potential is generated by upward flow of moisture-laden air, with a smaller negative potential on its flanks from downward infiltrating rainwater. The analysis indicates that the combination of SP and VLF measurements can characterize the evolving geothermal regime of intrusions above the water table.