Geometric void-multiscale model for evaluating the effect of bead width and layer height on voids in FDM parts

Abstract

PurposeThis paper aims to present a geometrical void model in conjunction with a multiscale method to evaluate the effect of interraster distance, bead (raster) width and layer height, on the voids concentration (volume) and subsequently calculate the final mechanical properties of the fused deposition modeling parts at constant infill.Design/methodology/approachA geometric model of the voids inside the representative volume element (RVE) is combined with a two-scale asymptotic homogenization method. The RVEs are subjected to periodic boundary conditions solved by finite element (FE) to calculate the effective mechanical properties of the corresponding RVEs. The results are validated with literature and experiments.FindingsBead width from 0.2 to 0.3 mm, reported a decrease of 25% and 24% void volume for a constant layer height (0.1 and 0.2 mm – 75% infill). It is reported that the void’s volume increased up to 14%, 32% and 36% for 75%, 50% and 25% infill by varying layer height (0.1–0.2 and 0.3 mm), respectively. For elastic modulus, 14%, 9% and 10% increase is reported when the void’s volume is decreased from 0.3 to 0.1 mm at a constant 75% infill density. The bead width and layer height have an inverse effect on voids volume.Originality/valueThis work brings values: a multiscale-geometric model capable of predicting the voids controllability by varying interraster distance, layer height and bead width. The idealized RVE generation slicer software and Solidworks save time and cost (<10 min, $0). The proposed model can effectively compute the mechanical properties together with the voids analysis.