Abstract
This research presents a method to design a non-circular planetary gear. Therein the satellite gear block consists of eccentric cycloidal gear and elliptical cycloidal gear, which have been given. The mathematical equations of two ring non-circular gears are set up according to the gearing theory considering the undercutting conditions. A numerical calculation program was written in Matlab to calculate and dynamically analyze this planetary gear. The examples presented in the paper clarified the design steps of the method. The simulation results show that the non-circular cycloidal gear can overcome the irregular tooth phenomenon on the traditional non-circular involute gear, and when it is necessary to design infinitely variable speed converters with large amplitudes, the coefficient λ should be adjusted rather than the coefficient μ.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: JST: Engineering and Technology for Sustainable Development
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.