Abstract
Radio frequency identification (RFID) tags with printed antennas are lower in cost but have lower performance than those with metal antennas. Printed antennas can replace metal ones if the performance is increased without raising cost. The performance of printed antennas can be increased if the series resistance in the antennas is lowered. The resistance is dependent on the line thickness and the resistivity of the conductive ink. Printed antennas with different line thicknesses were fabricated to investigate the effect of compaction and thickness on the resistance. The resistance of the printed antenna coils decreased by more than 40% after compaction, while the inductance and the parasitic capacitance were unchanged. RFIDs with compacted printed antennas were found to have significantly increased read range. RFIDs with thick printed antennas were fabricated and tested. These RFIDs were shown to have read ranges comparable to the RFIDs with copper wire antennas. Moreover, a geometry-independent plateau for the read range was found. The presence of a plateau is valuable for thick-line printed antenna since the plateau will enable the usage of low precision printing techniques to lower tag fabrication cost.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Electronics Packaging Manufacturing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
