Geological and geochemical characteristics of the Middle–Lower Jurassic shales in the Kuqa Depression, Tarim Basin: an evaluation of shale gas resources

Abstract

ABSTRACTMiddle–Lower Jurassic terrigenous shales constitute a set of significant hydrocarbon source rocks in the Kuqa Depression of the Tarim Basin. Until recently, however, most investigations regarding this set of hydrocarbon source rocks have mainly focused on conventional oil and gas reservoirs, and little research has been conducted on the formation conditions of shale gases. This research, which is based on core samples from nine wells in the Kuqa Depression, investigated the geological, geochemical, mineralogical and porosity characteristics of the shales, analysed the geological and geochemical conditions for the formation of shale gases, and evaluated the shale gas resource potential. The results show that the distribution of the Middle–Lower Jurassic shales is broad, with thicknesses reaching up to 300–500 km. The total organic carbon (TOC) content is relatively high, ranging from 0.2 to 13.5 wt% with a mean of 2.7 wt%. The remaining hydrocarbon generative potential is between 0.1 and 22.34 mg/g, with a large range of variation and a mean value of 3.98 mg/g. It is dominated by type III kerogen with the presence of minor type II1 kerogen. The vitrinite reflectance values range from 0.517 to 1.572%, indicating the shales are in a mature or highly mature stage. The shales are mainly composed of quartz (19–76%), clay (18–68%) and plagioclase (1–10%) with mean contents of 50.36 wt%, 41.42 wt%, and 3.37 wt%, respectively. The pore spaces are completely dominated by primary porosity, secondary porosity and microfractures. The porosity is less than 10% and is mainly between 0.5 and 4%, and the permeability is generally less than 0.1 mD. These results classify the shale as a low-porosity and ultra-low-permeability reservoir. The porosity has no obvious correlation with the brittle or clay mineral contents, but it is significantly positively correlated with the TOC content. The maximum adsorbed gas content is between 0.82 and 8.52 m3/t with a mean of 3.37 m3/t. In general, the shale gas adsorption content increases with increasing the TOC content, especially when the TOC content is greater than 1.0%. The volumetric method, used to calculate the geological resources of the Middle–Lower Jurassic shales in the Kuqa Depression, shows that the geological resources of the Middle and Lower Jurassic shales reach 667.681 and 988.115 × 109 m3, respectively with good conditions for the formation of shale gas and good prospects for shale gas exploration.