Genipin and glutaraldehyde based laccase two-layers immobilization with improved properties: New biocatalysts with high potential for enzymatic removal of trace organic contaminants

Abstract

This research proposes the preparation of a two-layer laccase biocatalyst using genipin or/and glutaraldehyde as cross-linking agents. The multilayer biocatalysts were prepared using different combinations of genipin and glutaraldehyde in the individual preparation of the first and second laccase layers. First, chitosan was treated with genipin or glutaraldehyde, followed by the immobilization of the first laccase layer to form a single-layer biocatalyst. Then, the immobilized laccases were coated once again with genipin or glutaraldehyde, and a new laccase layer was immobilized onto the system, resulting in the final two-layer biocatalyst. Compared to the single-layer biocatalysts, catalytic activity increased 1.7- and 3.4-fold when glutaraldehyde coating was used to prepare the second laccase layer. However, adding a second layer did not always produce more active biocatalysts, since the two-layer biocatalysts prepared with genipin (GenLacGenLac and GluLacGenLac) presented a decrease in activity of 65% and 28%, respectively. However, these two-layer biocatalysts prepared with genipin maintained 100% of their initial activity after 5 cycles of ABTS oxidation. Nevertheless, the two-layer, genipin-coated biocatalyst resulted in a higher removal of trace organic contaminants, since it removed 100% of mefenamic acid and 66% of acetaminophen, compared with the glutaraldehyde-coated biocatalyst, which removed 20% of mefenamic acid, and 18% of acetaminophen.