Abstract

In this article, a method was investigated for elimination of the oxide layers and sand inclusion which have been created by turbulence in a kind of pressure plate part of the gray cast iron that is used in automotive industries. The pressure plate was produced by green sand Disamatic vertical molding line in a four cavities mold. In primary design of the gating system, the parts included some defects after production. After reviewing by optic microscopes and scanning electron microscope equipped to energy dispersive X-ray spectroscopy, it was realized that these defects are double oxide layers. The simulation results showed that the melt velocity was more than critical velocity just before entering into the cavity in the pressurized gating system (PGS). This agent was related to several factors such as size and thickness of the gate, choke position and type of connection ingate to the part at its model. This can lead to create double oxide layers. Reynolds number (Re) was used to show the turbulence or the non-turbulence of the fluid. Thus, a new version gating system (NVGS) was designed to decrease the melt velocity by changing the design of the pouring cup, vertical and horizontal runners, wells, chokes and ingates. The NVGS design was evaluated by the simulation software and compared with PGS design. The results showed that the melt in the ingate at the NVGS was smooth and non-turbulence. In addition, the Re was less than its critical value. Accordingly, parts produced by NVGS design were produced without any oxide layers and sand inclusion defect and final inspections were confirmed.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call