Abstract
This paper proposes a new gate driving circuit for the solid-state pulsed power modulator (SSPPM) based on semiconductor devices. The proposed circuit can be easily implemented by applying a short gate signal to the bypass insulated gate bipolar transistor (IGBT), i.e., switches connected in parallel with the load instead of a pull-down resistor. The IGBT_BPs are turned on at the end-point of the pulse. It can quickly discharge the pulse voltage applied to the load. In addition, it can operate as bypass diode, which is used to protect the semiconductor switches when the gate signal malfunctions, by using the antiparallel diode of the IGBT. Moreover, power loss in the pull-down resistor used to achieve fast falling pulses can be eliminated by turning off the IGBT while applying the pulse state. Thus, the proposed circuit can be used for implementing SSPPM with small values of falling time and high efficiency. The circuit configuration, operational principle, relevant analysis results, and a PSpice modeling are presented and verified by the 10-kV SSPPM.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.