Abstract
This paper reports a gas pressure sensor using surface acoustic wave resonator (SAWR) based on both the field-induced electron emission and the micro-corona-discharging (MCD) phenomena. With the micron-scale finger-gap of electrodes covered with SiO2 passivation layer, the enhanced field-effect emission (FEE) at electrodes result in the micro-corona-discharging and thus the change in the dynamic resistance of SAWR. A high Q-factor SAWR was fabricated on ST-cut quartz substrate using microelectronics processing technology, and the gas-pressure-dependent return-loss was tested, and the MCD theory and the equivalent circuit model of SAWR were used to analyze the test results. Under argon pressure range from 0 to 601 kPa, the dynamic resistance of the SAWR varies from 24.569 to 41.589 Ω at 25 °C. The resistance rate reaches 69.3%, which is far higher than that of traditional piezoresistive pressure sensors. At the same time, the oxygen pressure was also tested by the SAWR as a comparison. The SAW-based gas pressure sensors have the potential for measurement of the super-high pressure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
