Abstract
Abstract The results concerning emission of gases from two commercial graphite protective coatings for moulds and cores (water and alcoholic) are given in the hereby paper. Investigations were performed in two systems. One of the systems was corresponding to conditions occurring inside the mould cavity immediately after its pouring with liquid metal (Method 1), while the second was simulating conditions deep inside the mould at a certain distance from the casting (Method 2). Investigations were carried out in the CO2 atmosphere and in the air. The water protective coating generated 1.5 to 3 times larger volume of gases than the alcoholic coating (in dependence on the measuring method and atmosphere). The smallest differences occurred in the air atmosphere, while the largest in the CO2 atmosphere.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
