Abstract

Gamma hearing measurements have been made in a low-Z assembly irradiated with 14-MeV neutrons and (n,n{prime}) gammas produced by a Texas Nuclear Model 9400 neutron generator. The assembly is composed of 144 magnesium sleeves (5cm {times} 5cm {times} 60cm {times} 3 mm thick) filled with graphite to simulate a fusion blanket test module. Heating measurements were made in the mid-line of the assembly using a proportional counter operating in the Continuously-varied Bias-voltage Acquisition (CBA) mode. The neutron induced atomic recoil signal was rejected by observing the signal rise-time differences inherent to radiations of different LET. The experiment was modelled using the one-dimensional radiation transport code ANISN/PC. The operating limits of this technique were identified by comparing measurements made at different positions in the assembly and then comparing these measurements to the calculated flux. 7 refs., 5 figs., 1 tab.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.