Abstract

Fiber Raman amplifiers in ultra wideband wavelength division multiplexing (UW-WDM) systems have recently received much more attention because of their greatly extended bandwidth and distributed amplification with the installed fiber as gain medium. It has been shown that the bandwidth of the amplifier can be further increased and gain spectrum can be tailored by using pumping with multiple wavelengths. In this paper, the distributed multi-pumping Raman amplifier has been studied and analyzed by testing two designed model of amplifier to obtain the gain of maximum flatness and bandwidth. Also we have investigated the effects of many parameters on the gain and bandwidth of Raman amplifier such as: pumping wavelength, offset wavelength, the relative refractive index difference and the number and location of the cascaded units used in the amplifier model design. The models is analyzed where six and eight Raman pumping of special pumping power and pumping wavelengths are lunched in the forward direction where each model is analyzed by two different way. The gain is computed over the spectral optical wavelengths (1.45μm ≤ λ signal ≤ 1.65μm). The differential gain of each unit of the amplifier is obtained according to the straight line-exponential model of a small maximum constant gain of 7.4×10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">-14</sup> m/W over an optical wavelength interval of 16 nm.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.