Abstract
In this study, a heat pipe system was installed into the mold used in the polymer processing to enhance the heating and cooling rate of the mold as well as to reduce the required thermal energy for the temperature control of the mold, and the characteristics of the system were experimentally investigated. The result showed that the maximum heat flux value of 18 kW/m2 was achieved at the individual operation. By using the system, thermal energy can be transported between a pair of the molds in the sense of thermal district. The result showed that the maximum heat flux value of 8.0 kW/m2 was realized under the thermal energy exchange. And it was expected that the energy consumption to control the mold temperature would be reduced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The Proceedings of Mechanical Engineering Congress, Japan
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.