FWI Using Reflections in Shallow Waters Offshore Abu Dhabi

Abstract

Abstract The Arabian Gulf near-surface geology is complex, with extremely shallow waters and a hard water bottom generating high amplitude short period multiples and thinly bedded high and low velocity layers creating high apparent anisotropy in the bandwidth of seismic surveys. Obtaining an accurate description of the velocity variations in the near-surface and at intermediate depths is a necessity for reliable imaging and positioning of the reservoir layers located underneath. We propose a two-step full-waveform inversion (FWI) of ocean-bottom node (OBN) seismic data from offshore Abu Dhabi. We update a velocity model, using both diving and reflected waves, to reach the required depth of penetration. FWI has become an industry standard for velocity model building. However, due to the oscillatory nature of seismic data, FWI is known to be subject to cycle-skipping, where the inversion process falls into a local minimum. This risk is mitigated by using an accurate enough initial model and the use of low frequencies. In the shallow waters of offshore Abu Dhabi, near-offset data suffer from strong mud-roll and guided-wave energy that are not properly modeled with acoustic FWI. We exclude these offsets from the input data and use diving waves, starting at 3.5Hz, to update the near surface. The diving waves penetration is limited to approximately one kilometer in this area and corresponds to the base of a shallow high velocity layer. To reconcile the kinematics of reflected waves, travelling mostly vertically and used for imaging, and diving waves, travelling mostly horizontally, and used in the velocity update, we need an accurate estimation of the anisotropy. This is obtained using Backus averaging from available well logs. For deeper updates, the data are processed to remove the mud-roll and guided wave energy. This allows for the inclusion of reflections and near offsets. The FWI update is performed to 10Hz and penetrates about 3km into the sub-surface. We applied this FWI workflow to a recent node survey acquired offshore Abu Dhabi. The velocity model obtained follows the main geological structures and accurately describes the velocity variations in the shallow sub-surface. The estimation of anisotropy is important to ensure good convergence of the FWI and for imaging and vertical positioning of the migrated events. The reverse-time migration (RTM) image obtained with the updated model shows improved focusing and simplified depth structures compared to the RTM image obtained with the smooth initial model. To the best of our knowledge, this is the first successful implementation of FWI, here combining diving and reflected waves, on a dataset from offshore Abu Dhabi. It is a step towards resolving buried anomalies such as karst features, that cause imaging distortions at deeper reservoir levels.