Abstract

The accurate control for the vehicle height and leveling adjustment system of an electronic air suspension (EAS) still is a challenging problem that has not been effectively solved in prior researches. This paper proposes a new adaptive controller to control the vehicle height and to adjust the roll and pitch angles of the vehicle body (leveling control) during the vehicle height adjustment procedures by an EAS system. A nonlinear mechanism model of the full-car vehicle height adjustment system is established to reflect the system dynamic behaviors and to derive the system optimal control law. To deal with the nonlinear characters in the vehicle height and leveling adjustment processes, the nonlinear system model is globally linearized through the state feedback method. On this basis, a fuzzy sliding mode controller (FSMC) is designed to improve the control accuracy of the vehicle height adjustment and to reduce the peak values of the roll and pitch angles of the vehicle body. To verify the effectiveness of the proposed control method more accurately, the full-car EAS system model programmed using AMESim is also given. Then, the co-simulation study of the FSMC performance can be conducted. Finally, actual vehicle tests are performed with a city bus, and the test results illustrate that the vehicle height adjustment performance is effectively guaranteed by the FSMC, and the peak values of the roll and pitch angles of the vehicle body during the vehicle height adjustment procedures are also reduced significantly. This research proposes an effective control methodology for the vehicle height and leveling adjustment system of an EAS, which provides a favorable control performance for the system.

Highlights

  • Since the first application of electronic technology to the vehicle air suspension system recorded in 1980s, electronic air suspension (EAS) system has gained wide attentions [1,2,3,4]

  • As a well-established vehicle suspension system, EAS system has been researched in depth and been used in a large number of vibration isolation occasions, such as the vehicle seat suspension and the railway vehicle suspension [7,8,9,10]

  • In order to prevent the phenomenon of vehicle posture instability, i.e., the peak values of the roll and pitch angles of the vehicle body are too large, which is mainly caused by the different payloads at four corners and the system parameters difference between the front and rear air suspensions, the effective control of the vehicle leveling is very essential for the EAS system dynamic performance [11]

Read more

Summary

Introduction

Since the first application of electronic technology to the vehicle air suspension system recorded in 1980s, electronic air suspension (EAS) system has gained wide attentions [1,2,3,4]. The heights at four corners of the vehicle body are adjusted by controlling the air mass flow rates flowing into or flowing out of the air springs for an EAS system. In order to prevent the phenomenon of vehicle posture instability, i.e., the peak values of the roll and pitch angles of the vehicle body are too large, which is mainly caused by the different payloads at four corners and the system parameters difference between the front and rear air suspensions, the effective control of the vehicle leveling is very essential for the EAS system dynamic performance [11]. The main contribution of this paper is that a novel control approach is proposed by combining the merits of SMC and FLC to address the vehicle height and leveling control problem of a full-car EAS system. (2) Height and leveling adjustment during the lowering procedure: To lower the vehicle body, the ECU generates control signals to open the discharging sole-

Vehicle body Air spring Unsprung mass
RT s
The basic fuzzy rule for the FSMC is defined as
Fuzzy sliding mode control
Critical pressure ratio b
Findings
With control
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call