Abstract
The present study has successfully applied fuzzy control logic in controlling the weld line position for an injection-molded part. Although only a simple molded part was dealt with here, the incorporation of fuzzy control with CAE software in controlling the weld line position is a breakthrough in the concept of mold-design optimization. During the analysis, only four calculations of decision and simulation were conducted before the final result was obtained, saving considerable time compared with conventional trial and error or computer simulation methods. Consequently, the mold-design process can be accelerated. Since the weld line does appear at the expected location in the actual molded part, the present results can provide a sound basis for developing mold-design optimization.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
