Fusion Length Requiring Spinopelvic Fixation in Lumbosacral Fusion with Anterior Column Support at L5-S1: Assessment of Fusion Status Using Computed Tomography.

Abstract

The lumbosacral (LS) junction has a higher nonunion rate than other lumbar segments, especially in long-level fusion. Nonunion at L5-S1 would result in low back pain, spinal imbalance, and poor surgical outcomes. Although anterior column support at L5-S1 has been recommended to prevent nonunion in long-level LS fusion, fusion length requiring additional spinopelvic fixation (SPF) in LS fusion with anterior column support at L5-S1 has not been evaluated thoroughly. This study aimed to determine the number of fused levels requiring SPF in LS fusion with anterior column support at L5-S1 by assessing the interbody fusion status using computed tomography (CT) depending on the fusion length. Patients who underwent instrumented LS fusion with L5-S1 interbody fusion without additional augmentation and CT > 1 year postoperatively were included. The fusion rates were assessed based on the number of fused segments. Patients were divided into two groups depending on the L5-S1 interbody fusion status: those with union vs. those with nonunion. Binary logistic regression analyses were performed to identify risk factors for LS junctional nonunion. Fusion rates of L5-S1 interbody fusion were 94.9%, 90.3%, 80.0%, 50.0%, 52.6%, and 43.5% for fusion of 1, 2, 3, 4, 5, and ≥ 6 levels, respectively. The number of spinal levels fused ≥ 4 (p < 0.001), low preoperative bone mineral density (BMD; adjusted odds ratio [aOR], 0.667; p = 0.035), and postoperative pelvic incidence (PI) - lumbar lordosis (LL) mismatch (aOR, 1.034; p = 0.040) were identified as significant risk factors for nonunion of L5-S1 interbody fusion according to the multivariate logistic regression analysis. Exhibiting ≥ 4 fused spinal levels, low preoperative BMD, and large postoperative PI-LL mismatch were identified as independent risk factors for nonunion of anterior column support at L5-S1 in LS fusion without additional fixation. Therefore, SPF should be considered in LS fusion extending to or above L2 to prevent LS junctional nonunion.