Abstract
Additive manufacturing (3D printing) offers a flexible approach for the production of bespoke microfluidic structures such as the electroosmotic pump. Here a readily accessible fused filament fabrication (FFF) 3D printing technique has been employed for the first time to produce microcapillary structures using low cost thermoplastics in a scalable electroosmotic pump application. Capillary structures were formed using a negative space 3D printing approach to deposit longitudinal filament arrangements with polylactic acid (PLA) in either "face-centre cubic" or "body-centre cubic" arrangements, where the voids deliberately formed within the deposited structure act as functional micro-capillaries. These 3D printed capillary structures were shown to be capable of functioning as a simple electroosmotic pump (EOP), where the maximum flow rate of a single capillary EOP was up to 1.0 μl min-1 at electric fields of up to 750 V cm-1. Importantly, higher flow rates were readily achieved by printing parallel multiplexed capillary arrays.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
